How can a vacuum cleaner be used to prolong its life?

To prolong the service life of the vacuum cleaner, you must use the vacuum cleaner correctly and learn how to maintain it after use. This will extend the life of the vacuum cleaner. Take a good look at the following methods:

1. Check whether the dust bag is clean before use, and use it after cleaning if necessary.

2. The continuous use time should not exceed 2 hours each time, so as to avoid overheating and burning of the motor.

3. The vacuum cleaner with dust indicator should not work after the dust is full. If it is found to be close to full, it should be stopped immediately to clean the dust.

4. Keep away from water pump, radiation source and stove when using.

5. Pay attention to the insulating protective layer of the protective wire when using it to prevent damage caused by dragging on the ground for a long time.

6. First remove large pieces of dirt in the place to be cleaned by the vacuum cleaner to prevent sharp objects from entering the vacuum cleaner and damaging the motor.

7. It is strictly forbidden to put your hands or feet under the suction mouth to avoid danger.

8. The vacuum cleaner cannot be used to absorb debris such as metal chips or burning cigarette butts to prevent damage to the motor and dust bag.

9. The vacuum cleaner should not absorb muddy water or other liquids to prevent leakage and damage to the motor.

When using the vacuum cleaner, you should also pay attention to the following maintenance and maintenance methods:

1. After using the vacuum cleaner, the vacuum cleaner and accessories should be wiped clean with a damp cloth, and then dried naturally in the air. The dirt in the dust bag should be removed in time. If it is not used temporarily, the dust bag should be washed with warm water, and then dried naturally in the sun. Remove hair and lint from the brush floor.

2. Always check the wear of the brushes. If the wear is found to be serious, the brushes should be replaced with new ones.

3. Always check the fastening parts, if they are loose, they should be fastened at any time.

4. The brushes on the motor of the vacuum cleaner are also easy to wear, so pay attention to maintenance and replacement.

5. The bearing of the motor should be lubricated regularly.

6. Do not place the vacuum cleaner in a place with damp and corrosive gas.